Cisco Systems Media Gateway Controller Node Manager Run the installation setup script by entering

Chapter 2 Installing Cisco MNM

Performing a New Installation of Cisco MNM

•If your machine does not have a DVD-ROM drive, see Table 2-5in the Troubleshooting section for steps on mounting a DVD-ROM drive from a remote machine.

Step 2	Write down the CiscoView server IP address, which is needed for Task 9 when you install Cisco MNM.
Step 3	Run the installation setup script by entering:
	# sh setup.sh
	or
	# ./setup.sh
Step 4	Press Enter to read the license agreement.
Step 5	Enter Y to accept the license agreement and proceed with the installation, or enter N to exit the
	installation.
Note	• Error messages or warning messages appear if you do not have the required or recommended Server
	and Client patches.

•CiscoView must use the default port number 1741. Do not modify this number during installation.

Step 6 Select one of the following installation modes:

a.Typical to select the components and install the selected components in the default location (/opt/CSCOpx). This is the default installation mode.

b.Custom to select optional components, customize the settings, and to specify the location.

Step 7 Select CiscoView 6.1.8 to begin the installation. When the installation is complete, the following messages display:

Software Installation Tool Completed

Possible Warnings/Errors Encountered

The warning and error messages that appear after these messages do not hinder the installation. They only indicate that you need to take corrective actions after the installation is complete.

Your Solaris machine has successfully installed CiscoView.

For more CiscoView installation details, see the Installation and Setup Guide for CiscoView 5.4 (Standalone) at

http://www.cisco.com/en/US/products/sw/cscowork/ps4565/products_installation_guide_book09186a0 0800e19f6.html

To get the supported device list, see the User Guide for CiscoView 6.1.8 at

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_ciscoview/6.1.8/user/guide/cv618_ug.html

After installing CiscoView 6.1.8, get the support list for Signaling Link Terminals ITP-Ls and Media Gateways (MGWs) by logging in to the CiscoView server. If your Cisco ITP-L or MGW isn't included in the list, download the device package at

http://www.cisco.com/cgi-bin/Software/CiscoView/cvplanner.cgi

Add the device package by following the instructions provided in the readme file.

Cisco Media Gateway Controller Node Manager Installation Guide

2-8 OL-18332-01