Chapter 2 Installing Cisco MNM
Performing a New Installation of Cisco MNM
Note Enter n and press Enter if you want to change the hostname for the management server.
Step 9 Press Enter to confirm the hostname and corresponding IP address of the management server.
Note Enter n and press Enter if you want to change the values.
The installation process begins and takes several minutes. When the installation is complete, a message indicates that the Cisco EMF Server Package installation completed satisfactorily.
This completes the Cisco EMF installation procedure on the presentation server.
Note After installing the Cisco EMF 3.2 base version, you must install Cisco EMF Service Packs 7, 7.1, and 7.2. See “Installing Cisco EMF Service Packs” for more information.
Installing Cisco EMF Service Packs
Cisco MNM requires Cisco EMF Service Packs 7, 7.1, and 7.2. See the release notes for additional patch requirements.
To install Service Packs 7, 7.1, and 7.2, follow these steps.
Caution The Cisco EMF Service Packs must be installed in this order: 7, 7.1, and 7.2.
Step 1 Insert the Cisco EMF 3.2 Service Pack 7, CD #2 in the
Note The Cisco EMF 3.2 Service Pack is also available at
Step 2 Change the directory to cdrom using the following command:
#cd /cdrom/cdrom0
Step 3 Determine your current Cisco EMF version and patch level by entering this command:
#./cemfinstall
Step 4 Proceed to Step 5 if Service Pack 7, 7.1, and 7.2 are not listed. Otherwise, you can skip this installation procedure for Cisco EMF service packs.
Step 5 Start the Cisco EMF installation script using the following command:
#./cemfinstall
Step 6 Choose the package to install.
Note If you have a Cisco EMF Server installed, you can install only the server patch. If you have a Cisco EMF Client installed, you can install only the client patch.
|
| Cisco Media Gateway Controller Node Manager Installation Guide |
|
| ||
|
|
| ||||
|
|
|
|
| ||
|
|
|
| |||
