Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP
Warning - default Gateway 10.1.1.1 is not allowed in the IP
Access list 2 permits all addresses while Access list 1 denies it. Apply and Save this configuration? [yes/no]: n
Setup procedure aborted, no configuration changes made.
EXAMPLE #2:
Following is an example of a configuration that was applied and saved to the startup configuration as well as to an FTP site.
Although not demonstrated in this example, it is recommended that you always view the configuration before applying it.
Data collection for | the system | configuration | is completed. | |||
Would | you | like | to view the new | configuration | before it is applied? [yes/no]: | |
Apply | and | Save | this | configuration? [yes/no]: | y |
(New configuration would be displayed here)
The running configuration would be overwritten by the changes you have just entered, are you sure? [yes/no]:y
The new running configuration will be saved to the startup configuration. Do you want to save a copy of the startup configuration file in a remote station? [no]:y
Enter a full FTP path of the remote destination: ftp://vk:vk@10.1.1.253/h:/copyofstartup.txt Committing configuration...
Configuration completed successfully.
Saving configuration...
Writing general configuration file to temporary location...
Copy temporary file to final location...
Done!
EXAMPLE #3:
Following is an example of a configuration that was aborted, although no errors were detected.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]: Apply and Save this configuration? [yes/no]: n
The changes you have just entered would be discarded, are you sure? [yes/no]:y
Setup procedure aborted, no configuration changes made.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
| ||
|
|
|