Chapter 6 Cabling the Line Ports and Completing the Installation
Connecting the line ports to the network
Fiber Specifications
The following table presents the fiber specifications. The SCE 1000 may be ordered with either Multimode or Single Mode transceivers The transceiver type is indicated on the front panel under the ports. Note that both transceivers on any individual SCE 1000 are the same, either 850nm Multimode OR 1310nm Single Mode.
Table | Fiber Specifications |
|
|
| |
|
|
|
|
|
|
SCE Model |
| Transceiver | Transmit Power | Receive Power | Typical (Max.) Distance |
|
|
|
|
| |
SCE 1000 2xGBE | 850nm Multimode | • 750m for 50µm Core | |||
MM |
|
|
|
| Diameter MMF |
|
|
|
|
| • 400m for 62.5µm Core |
|
|
|
|
| Diameter MMF |
|
|
|
|
| |
SCE 1000 2xGBE | 1310nm FRP laser | 10 km for 9.0µm Core | |||
SM |
| Single Mode |
|
| Diameter SMF |
|
|
|
|
|
|
Cabling the GBE Port
Warning Class 1 laser. Avoid exposure to radiation and do not stare into open aperture.
To cable the SCE 1000 GBE line port, complete the following steps:
Step 1 Take the appropriate fiber optic cable (see Fiber Specifications (on page
Make sure to push on the connector until you hear a click, which indicates that the connector is fully inserted and secured in the receptacle. Always make sure that you insert the connector completely into the socket.
Figure
Step 2 Verify that the link LED is green.
If the link LED does not light, try removing the network cable plug and reinserting it firmly into the module socket.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
| ||
|
|
|