4-6Compaq 3000 Series UPS Operation and Reference Guide

Changing Configuration Parameters

The Configure mode may be entered from the Operate or Standby mode.

IMPORTANT: If the STANDBY button is pressed while in the Configure mode, the UPS will enter Standby mode, and power to the load segments will cease.

1

2

3

4

Figure14-3. Configure mode controls

2ON LED (LED 16)

3ON button

4STANDBY button TEST/ALARM RESET button

To change configuration parameters:

1.Place the UPS in Configure mode by pressing the ON (2) and

TEST/ALARM RESET (4) buttons simultaneously. Release the buttons when the acknowledgement beep sounds.

2.The top left LED on the front panel LED display should begin to blink, indicating that configuration parameter 1 is selected.

3.To determine if the selected configuration parameter value is ON or

OFF, check LED 16 (1)—if LED 16 is ON, the selected parameter is also ON.

Page 52
Image 52
Compaq manual Changing Configuration Parameters, 6Compaq 3000 Series UPS Operation and Reference Guide