Compaq CP-2E manual Dhcp

Advanced Setup Icons

4.For user-defined protocols, select the Service Type (TCP or UDP) to block. This will not block all TCP or UDP traffic, just that traffic of the matching protocol type or port number.

5.Click Apply. The Connection Point CP-2E must be rebooted for applied changes to take effect.

6.Click OK. You can reboot the Connection Point CP-2E at any time by clicking the Reboot button at the left.

DHCP

The Connection Point CP-2E has an integrated DHCP server that allows you to automatically configure TCP/IP settings on computers attached to the local network. The DHCP server can provide the following settings to PCs on the local network:

>IP address

>Subnet mask

>Default gateway (which is the LAN interface IP address of the Connection Point CP-2E)

>DNS server

DHCP: Displays the status (enabled or disabled) of the integrated DHCP server. If you disable the integrated DHCP server, you must configure the TCP/IP networking settings on each of your PCs manually.

DHCP Start Address: Displays the first IP address to be leased out by the DHCP server. The default is 192.168.1.11.

DHCP End Address: Displays the last address to be leased out by the DHCP server. The default is 192.168.1.254.

5–14 iPAQ Connection Point CP-2E User Guide