Installation
Outline of Installation Procedure
This chapter details the following steps required for Compaq R6000 UPS installation:
■Unpack the Compaq R6000 UPS.
■Assemble the rails in the rack.
NOTE: If installing an Extended Runtime Module (ERM) with the Compaq R6000 UPS, the ERM must be installed at the bottom of the rack, with the UPS immediately above. If the UPS is installed without an ERM, the UPS must be installed at the bottom of the rack.
■Install the Compaq R6000 UPS chassis on the rails.
■Wire the Compaq R6000 UPS. Have a licensed electrician attach the REPO port.
■Have a licensed electrician wire the UPS to utility power
■Install any optional ERMs.
■Complete the assembly of the Compaq R6000 UPS in the rack; install the batteries after the chassis is in place and all wiring is complete.
■Connect UPS communication ports to the host computers, and install any hardware option cards and power distribution units (PDUs).
NOTE: Perform installations before starting the UPS. It is possible to install options after installation of the UPS, however, the UPS will have to be shut down. This will cut off power supply protection for connected devices.
■Charge the batteries
■Place the UPS in Operate mode.
