Compaq R6000 manual System Setup, Set Hardware HW Configuration

4-14Compaq R6000 Series UPS Operation and Reference Guide

System Setup

To change the system setup, the correct password must be entered. The six digits for the password [0-9 & A-Z] are selected using the Center and Enter buttons.

1.Choose the first digit using the Center button’s UP and DOWN arrow keys.

2.Press the Center button’s RIGHT arrow key to move to the next digit.

3.To change a digit, use the Center button’s LEFT arrow key to go back.

4.After the entire password has been entered, press the Enter button.

NOTE: The password must be six characters long. The default password is “COMPAQ.”

To establish or change the password, see “Set Password,” later in this chapter.

Enter Password

COMPAQ

IMPORTANT: The Password must be six characters in length. Once entered, record the password. If the password is forgotten or lost, contact an authorized Compaq Service Provider.

Set Hardware (HW) Configuration

Load Segments

This Submenu provides a means to specify the number of individually-controllable load segments (from 1 to 5).

Set HW Config

→Load Segments

By pressing the Enter button, this Submenu appears

Load Segments

(0-5)