Compaq SW3323, SW3324, SW3322 manual User Access, Factory Defaults, 2User Interface

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3-2User Interface

User Access

There are two modes of access to the user interface: READ-ONLY and READ/WRITE. READ-ONLY access allows you to view switch information, but not modify any operating parameters. READ/WRITE access allows you to both read and modify switch information. You are required to login with a password before obtaining READ/WRITE access. The factory default password is “public” (lower case), allowing full READ/WRITE access until a new password is set.

To use the console menus, do the following:

1.Type the letter associated with the desired option.

If the selected item is a submenu title, the submenu is displayed when you enter the letter.

2.Enter the parameter requested by the screen prompt.

If the selected item is a parameter, the system displays a prompt for the entry of a new parameter value. If the value entered is invalid, a beep sounds, or a message displays, requesting you to enter a valid value.

Factory Defaults

Table 3-1 lists the factory default settings for the switch configuration parameters. Each of these parameters can be changed via the console menus or Telnet.