Chapter 4 Common Configuration

This table describes the parameters that can be modified in the Management Port Setup page.

Parameters

IP Address

Network Mask

Management Gateway IP

Description

The LAN IP address of the access point is set by default to 192.168.168.1.

When the DHCP server of the AP is enabled (unless you set a different DHCP Gateway IP Address), this LAN IP Address would also be allocated as the Default Gateway of the DHCP client.

The Network Mask serves to identify the subnet in which the access point resides. The default network mask is 255.255.255.0.

(Optional) The Management Gateway here acts as the equivalent of the Default Gateway of a PC, to allow the access point to communicate with devices on different subnets. For instance, if you want to access the unit from the Internet or from a router on the LAN, you can set the IP address of the router as the Management Gateway IP.

The Management Gateway IP address of the access point is set to nil by default.

The next two fields (DHCP Start IP Address and DHCP End IP Address) allow you to define the range of IP addresses from which the DHCP Server can assign an IP address to the LAN.

DHCP

Start

IP

This is the first IP address that the DHCP server will assign. The value that you

Address

 

 

input here should belong to the same subnet as the access point. For example, if

 

 

 

the IP address and network mask of the access point are 192.168.168.1 and

 

 

 

255.255.255.0 respectively, the DHCP Start IP Address should be 192.168.168.X,

 

 

 

where X can take any value from 2 to 254. It is pre-set to 192.168.168.100.

 

 

 

This is the last IP address that the DHCP server can assign. It should also

DHCP

End

IP

Address

 

 

belong to the same subnet as the access point. For instance, if the IP address and

 

 

 

network mask of the access point are 192.168.168.1 and 255.255.255.0

 

 

 

respectively, the DHCP End IP Address should be 192.168.168.X, where X can

 

 

 

take any value from 2 to 254. It is pre-set as 192.168.168.254.

 

Though usually, the DHCP server also acts as the Default Gateway of the DHCP

DHCP Gateway IP

 

 

 

client, the access point gives you the option to define a different DHCP Gateway

 

 

 

IP Address, which will be allocated as the Default Gateway of the DHCP client.

 

 

 

The DHCP client will thus receive its dynamic IP address from the access point

 

 

 

but will access to the Internet or to the other LAN through the Default Gateway

 

 

 

defined by the DHCP Gateway IP Address.

 

 

 

For instance, when the unit is used in Access Point Client mode and connects to

 

 

 

an Internet gateway, X, a PC wired to the access point will be unable to obtain a

 

 

 

dynamic IP address directly from X. But if you enable the DHCP server of the

 

 

 

access point and set the X as the DHCP Gateway IP Address, the PC will then

 

 

 

obtain its IP address from the access point and access the Internet through X.

 

 

 

 

28

Page 29
Image 29
Compex Technologies WPE54 manual Parameters, Description