Compex Technologies WPE54 manual WDS Configuration Setup

Chapter 4 Common Configuration

The following steps will guide you in setting up WDS in the access point.

WDS Configuration Setup

From WLAN Setup under Configuration, click on Advanced which shows the WLAN Advanced Setup page.

Go to the Extended Features section. Click on the WDS Configuration button.

As illustrated on the WDS Setup, the WDS feature is Disabled by default.

Select Enable from the WDS Global Control drop-down list to operate WDS.

Click on the Apply button.

At the WDS Status page:

Click on the Add button to expand your WDS.

Please note that if you auto select your frequency channel (SmartSelect), you are not allowed to activate WDS Global Control.

NOTE

To configure WDS, all your access points must be in the same channel; and both your access points at opposite WDS link must have each other’s wireless MAC address

54