Viper Service Manual
Table 41
Step | Action |
7.Rotate the Product/BRIX valve to the BRIX position and open the valve at the end of the tube.
8.Hold a waste container under the BRIX tube to collect the sanitizing solution from the syrup line and open the manual syrup flow valve to start filling the syrup line with syrup. Continue to hold open the syrup flow valve until syrup starts coming out of the BRIX tube.
9.Perform a BRIX setup. See “BRIX Setup Menu” on page 32.
10.Fill the barrel with product as described in Table 22.
11.Perform motor calibration. See “Calibrating a Motor” on page 35.
Cleaning the Water Filter
The water filter screen in the rear of the unit should be removed and cleaned every six months, during the preventative maintenance procedures. To inspect and clean the filter screen, perform the procedure in Table 42. Refer to Figure 34 for water filter location.
Water
Filter
| Figure 34. Water Filter Location |
| Table 42 |
|
|
Step | Procedure |
|
|
|
|
1. | Disconnect power from the unit. |
|
|
2. | Turn off and disconnect the water supply to the unit. |
|
|
3. | Remove the rear cover of the unit. |
|
|
4. | Disassemble the water filter. (Use two wrenches, if necessary) |
|
|
5. | Remove the filter and rinse it under running water to remove any debris. |
|
|
6. | Reassembe the filter. |
|
|
7. | Connect and turn on the water supply to the unit. |
|
|
8. | Check the filter for any leaks. |
|
|
9. | Replace the rear cover. |
|
|
10. | Reconnect power to the unit. |
|
|
|
|
© 2010, IMI Cornelius Inc. | - 49 - | Publication Number: 621360041TBSER |
