TOUNLOCK/MOVETHERAILS
See Figure 15.
Thefront and back rails will need to be positionedsothey
do nottouch thefloor when the Sagstandis closed.
Usingthe bottom scaleas a guide, the scalewill need to
bealigned to the saw blade at the 14 in.mark. To unlock
andmove t_e mils:
•Loosenthe front rali clamps by pushingthe leverto the
left.
•Slidethe ra'dto the desired position.
•Securethe ragin position bypushing the clampto the
right.
•Repeatshove steps with the rear railplscingit in the
same locationas the front rail.
NOTI:-'When the rails are moved tothe right, usecaution
toavoid trippingon the front leg brace.
RELEASE
LEVER
IL
CLAMP
_g. 15
TO CLOSE THE LEG STAND AND MOVE THE SAW
See Figure16.
Storethe slidingmiter table on the back of thesaw
cabinet.See To Store the Tab/e Saw A_ssories onthe
previouspage. Next, set the frontand back ransto 14 in.
asdescribed above.
NOTE: Never closethe leg stand orattempt to move the
tablesaw untilboth the above steps are complsted.
Tocfoae the legstand:.
•At thesame time, step on the releaselever,grasp the
grips,and t_ the handles op andaway from the body.
• Push the table saw until the releaselever clicksand
locksinto place.
TomoYa the |eg s_and;
•Holdingthe gripsfirmly,pu(tthe handlestoward
youuntUthe lag stand and saw are balanced on the
wheels.
•Pushthe saw to the desiredlocation then eitheropen
thelag stand for immediate saw operationor store the
sawin a dry environTnent.
NOTE: Never movethe table saw unlesstheslidingmiter
table issecurely stored.
Fig.16
TO REMOVE /REPLACE THE THROAT PLATE
,..%eFigure1.7,
•Raisetheblade 2 in. above the saw table.
• Loosentha screws inthe throat prate.
•Liftthe throatplate from the saw,
•Toreinstallthe threatplate, af(gn theholes inthe throat
platewiththe holes inthe saw table.
•Ratightenthescrews, being carefulnot to overt_ghtan,
whichcan cause the throat plate to bow or bend.
19
Fig.17