• P_aceasupport/,thesameheight assaw tablel behind
the.saw for thecut work.
• Make sure the wood is clear of the blade before turning
on ti'_e,_Lw.
•Usea pushblockor pushstick to movethe wood
throughthe out past the bla_de.Never push aemafl
piece of wood into the blade with your hand,always
usea push stick. The use of pushblocks, pushsticks,
andfeathathoards are necessarywhen ma_rngnon-
throughcuts.
•Standto the side of the wood as itcontacts the blade
to reducethe chance of injuryshould kickback occur.
Never stand directly in the line ofcut.
•Makesure thewood iss[earof the blade beforeturning
onthe saw.
•Letthe blade b_Jildupto full speed before feeding the
workplece intothe blade.
•When thecut is made, turn the saw off.Wait for the
bladetocome to a completestop beforereme_ng the
wo_pieoe.
RiPCUT
RiP
FENCE
MAKING AMITER CUT
See F-agure43.
It is recommendedyou rnsketest outs on scrap wood.
_k WARNING: Make sure the blade guard assembly
isinstalledand working pmper]y to avoid serious
poes_is injury.
•Removethe rip fence by liftingthelocking handle.
•Set themiter gauge tothe desired angle and tightsn
the lockknob.
•Placeasupport(the same height as sawtable) bah'rod
the sawfor the cutwork.
•Make surethe wood is clear 0f the bladebeforeturning
onthe saw.
•Letthe blade bugd up to full speed before moving the
work,piece intotheb_ade.
•Feedthe work:pieceintothe blade untilthe out has
beencompleted.
MITERCUT
BLADE
MITERGAUGE
ANGLED HEIGHT
AOJUSTING
HANDWHEB.
Fig.43
MAKING A BEVEL CROSS CUT
See Ffeures44 -45.
Itis recommendedthat you place the pieceto be saved
onthe leftside of the blade and thatyou make stest cut
onscrap wood.
XWARNING: Makesure the blade guardassambly
isinstsJlsdandworkingpmpedy to avoid serious
pose'lois_n)ury.
•Untookthe bevel Iocking 1ever.
•Removethe ripfence by liftingthe [o,_kinghandle.
•Turnthe heightadjustinghandwhesl untilthe bevel
indicatorisat the desiredangle. Push the beve(
lockingleversecurelyto the left to lockthe angle.
•Setthe blade to the correctdepth for theworkpiece.
32