ACCESSORY TABLE USAGE
Th|saccessory table has been spec'dtcaltydesignedfor
usewith listed Craftsmen Routars.The hole pattern on the
accessorytable has notbeen drffladto accommodateall
reuters.Reuters must not exceed 3 HP (maximum devel-
oped) or weigh morethan 12-1/2 Ibs.Reutersmust have
took-onswitch feature.
TABLE CLAMP|NG BRACKET
See Figure 51.
The leveron the accessory table wilt.tightenthe table se-
curelyto the front rail.The weight of the muter may cause
theaccessory table to loosen orhave movementst the
rearof the table. To avoidthis, installthe table clamping
bracket.
NOTE: Positionthe table clampingbracket so that the
accessorytable iscentered over it.
II Slide one ofthe T-nuts into thefront channel of the
rearrail and underthe aooeseorytable.
•The table clamping bracketfitsin the bottom slot of
therear rail and the slotted top ofthe bracket wraps
aroundthe raised portion onthe undersideof the
accessorytable.
•Securewlth a 5/16 in.washer and a5/16-18 x 3/4 in.
knobbolt.
•Tighten the knobbolt securely.
TABLECLAMPINGBRACKET
SHOWNCOMPLETELY _
ASSEMBLED__,._
ACCESSORY L L_L)_
T.,ETABLECLAMPING
BRACKET
T-NUT
_/'16in.WASHER
KNOBBOLT
END
CAP
Fig. 51
T-NUTBETWEEN
ADJUSTMENT
SCREWS
REAR
ADJUSTMENT
SCREW
RIPFENCESHOWNLOCKEDAGAINSTSAWBLADE
Fig, 52
TO INSTALL T-NU'£_ FOR GUIDE FENCE
BRACKETS
SeeFigures52.53.
•Placerip fence againstblade and lock in place,
•Usingtheappropriate hex key suppliedwith yourtable
saw,remove the rearadjustment screwand washer on
top ofthe rip fence.
•Slideone ofthe T-nuts intothe top channelof rip fence
and placebetween the two adjustmentscrews.
NOTE:T-nuts installfrom the rear of the ripfence.
•Replacethewasher and the rear adjustmentscrewand
tighten securely.
•Checkthe ripfsncs for squarsnesswith ths saw blade,
• Unlock the ripfence, slide it away from the saw blade,
and lockit in place,
Slidethe fourremainingT-nutsinto the top channelof
ripfence.
NOTE:FiveT-nuts shouldbe in the top channelof
therip fencewith only one of them between the
adjustmentscrewson the rip fence.
37