UNPACKING
Thisproduct requiresassembly.
• Carefullyliftthe asw from the cartonand place it on a
level worksurface.
NOTE=This tool is heavy.To avoidback injury,keep
yourknees bent and liftwithyourlegs, not yourback,
and do not lift saw without help.
•Inspectthe toolcarefullyto make sure no breakage or
darnags occurredduringshipping.
•Do not discardthe packingmaterial untilyouhave
caref_Jttyinspected andsstistacto_tyoperated the too_.
•The _aw isfactory setfar accurate cutt'_ng.After
assemblingit, check for accuracy.If shipping has
influenced _e settings,refer to specificprocedures
expta'medin_is manual.
•If any parts aredamaged ormissing, plasea call
1-800-932-3188 for ass]stance.
_" WARNING: if any parts are missing, do not operate
th_stoo_unt_the missing parts are replaced.Failure
to do so could rssultin possibleseriouspersonal
injury.
_1= WARNING: Do not attempt to modify this tool
orcreate accessories not recommendedfor use
with this tool.Any such aiteratlonor modification is
misuseand could resultin a hazardous condition
leading to possible se_oL;spersonalin)ury.
AWARNING: Do not connectto power supply until
assemblyis complete. Fa(lursto comply could result
in accidentalstarting and possible seriouspersonal
injury.
_1= WARNING: Do not liftthe sawwithout help. Hold
it close to your body.Keep your kneesbentand
(iftwith yourlegs, notyourback. Ignoringthese
precautionscan resultin back injury.
•Stepon the release]everand pull the gripstoward you
at the sametime.
•Once the leg stand is released from the release lever,
easethe leg s_n rttoward the _ocr by pashlngth_ grips
toward the floor.
•Withyourhandsonthegr_ps,pushthslegstand_owards
the ground untilthe _.bis sawis in an upright pos'_tion.
NOTE:The releaseleverwillclose overthe center brace
lockingthe legstand in an upright poslton.
GRIPS SAW
BASE
RELEASE LEG,STAND
LEVER
Fig.7
A
Am, WARNING: Never standd}rs_')yin line with the
blade orallow hands to cornscloser than 3 in. to the
blade. Do not reach over or across the blade. Failure
to heed this warning canresult in seriouspersonal
iniury.
A
me, WARNING" Toavoid seriouspersonalinjury, always
make surethe table saw is securely mountedto
thisleg stand. NEVER remove the saw from the 1eg
stand.
TO OPEN THE LEG STAND
See Figures7- 8.
•Graspthe grips on the saw table and s_and itupright as
shownin figure 7 be(ow.
cENTER
BRACE
Fig,8
16