Craftsman 315.21829 manual See Flours21

		I!_STIIIG CI_II,N[P			TO CHECK	SLDNG M_'ER TABLE ASSEMB!3/'
		MITERFENCE	KNOB	ATI'ACHMEN'T
					The square relationshipbetween the blade and the miter
	MITER	HOLDER		BOLT	fence as it travels the entire distancefrom the frontto the
					rear of the miter table base duringa cut is very important
	FENCE	HOLE"A"
	\
		,			for m_ng preciseand accurate cuts.The slidingmiter
					table assembly has been preset at the factory. However,
					misallgnment during shippingor requirementsfor very
				LOCATORPiN	precise and accurate cuts may requirerce[ignment.
					To avoid unnecessarysetups arid ad.iuatments,we
					suggest that you check these setups carefullywith a fram-
					ing square and make practicecuts in scrap wood before
					making finishcuts in good workpisces.
	INDICATOR				NOTE: Followthe general rule of measuring twice and
					cuttingonce.
				TABLESLOT
					Do not loosen any screws. Once screws have been loos-
	HOLE=B"
					ened, settings must be reset.
	QUICKSTOP		HOLE"C"	Fig. 20
					Two basic checks should be made before using the miter
TO	LOCK SLIDING MITER		TABLE
					table"(1) the miter base must be parallelto the blade as
See Flours21.					the table slides fTomthe front to back, and (2) the miter
The miter table elides allowing the operatorto elide the					fence must be squareto the blade when set at exactly
workplsce across the saw, A miter slide lock is mounted					zero (0") on the rafter table scats.
on the front of the miter table to lock it in place. The miter					NOT_ The miter tablehas adjus_ant screws for squar-
slide lock is placed in a slot on the base to align the miter					ing miter fence tc blade and maintaining0° scale settings
tabla with the h'ontedge of the saw table. The sliding					when miter base adjustments are rsc,uired.These checks
miter table shouldbe locked for any cut in which the					and adjus't_entsare exp_ined in step-by-step procedures
operator prefersa fixed table.					in the Opera#on sectionend depend on each other.
•	To lock the miter table with the base projectingto the				TO INSTALL	ACCESSORY TABLE
	front, place miter slide lock in the back slot on the				See Figure22.
	base.
					• Fit the tabs on the back of the accessory table into the
•	To lock the miter table with the base projectingto the
					rear rail.
	back, place miter slide lock in the front slot on the				• Posi_onthe slot on the undersideof the accesaory
	base.
					table ontothe frontrail and tighten the lever securely.
					NOTE: To use the optional routeraccessories included
					with this product, refer to the Operationsectionfor usage.
	MITER					ACDESSORY
						TABLE
	SLIDELOCK				TO
						REARRNL
					LOCK

SLOT8FORLOCKING

MITERTABLE

Fig. 21	FITUP OFT_B,LE
	IKTOREARRAIL

\

TO

UNLOCK LEVER

Fig. 22

21