• Tightenhex nut securely.
Adjustrightrear screw from underneathmiter table to
removeexcessiveplay.
Tighten hex nutsecurely.
Recheckyoursetups carefully.Alse make surea[[
screws,hex nu_s,etc., h_ve been tightened securely.
If slidingmitertable assembly is stillnot square with
theblade, repeat the above proceduresas needed.
Makesure that sfidss remainsquareto miter base
edo,etopreve_ =oookir=_=whichwill resultinexcessive
playin miter table.
TO ADJUST QUICK STOP
See Figure38.
Thequick stop is presetat the factory to stop the miter
fenceat sxactiy zerodegrees. However,when sliding
miter tableadjustmentsare made, these adiustmentsmay
causethe quickstop to need adiusting.Check qu(ck stop
withmiterscale set at zero degrees. If adjustmentsare
needed,proceedwith the followingsteps:
Loosenthe eccentric screwholding thequick stop.
Piecethe quickstop againstthe miter fence with miter
scaleset at zero degrees.
Adjusteccentricscrew untilit holdsquick stop securely
a_]aJnstmiterfence.
• Rstk..lhtenhe);nut, secur{ngeccentric screwand q,qck
stop.
Checkyourwork. If the quick stop isnot at zero
degrees,repeat above steps.
tQ
Fig.35 QUICK
STOP
Fig. 36
29