TO IN_rALL BEVEL HANDLE ASSEMBLY
See F-t_re 12.
• Liftthe end rap offthebevel handle assembly usinga
fiatb|ade screwdriver,
•Holdthe nylonnut securelyand turn the screw counter-
clockwise toremove thenutcompletely.
NOTE: Do not remove the screw from thehandle or the
washerfrom the end of the screw.
•Placethe nylon nut intothe recessed hole on the back
ofthe height adjustinghandwheel and hold in place,
•Slidethe handle,screw, and washer into the hole on the
he(ghtadjustln9l_n_'_heaL
•Usinga fiatheadscrewdriver, turn the screw clockwise
andtighteninplace.
•Pushthe end cap back inplace on the end of the
handle.
HEXNUT
HEIGHT/BEVEL
ADJUSTINGRANDWHEEL
WONTRAIL
cLAMP
FRONTPAIL
SQUARERAIL
HOLDERNUT
Fig. 1"3
BEVELHANDLE
WASHER
TO INSTALL FRONT AND BACK RAILS
See Figures 13 - 14,
•Loosenthe frontrail ciarnps one half turnfi'om the
tightenedposition. Loosenthe square ragholdernut
one-fourth(1/4)turn"_oallowthe front ra_to slide ovsr
it.
• Mount the _ont railwith thescalefaoincj the outside
towardthe operator.
•Check to make sure the rail clamps willsecurelyclamp
therai( beforeslidingthe entire assembly into position.
If not, tighten the squarerail holdernut one-fourth(1/4)
turnand recheck.
•Slidethe rail intoposition over both clamps and
secure.
•Mountthe rear rail,following the same ciamping
procedureas shownfor the front rail
SQUARERAIL
HOLDERNUT
REARRAIL
CLAMP Fig.14
18