TOAUGNTHEMITERLOCKINGCLAMPS
See Figure66.
The miter locking clamps are presetat the factory but may
requireadjustingafter extendeduse or if damageoccurs in
shipping.
•Unplugthe saw.
•Loosenthe set screw behind each lockingclamp.
• Loosen thescrew on top of each Iockingclamp.
• Uft the locldng clamp to the up position,
•Pushthe clamp forward tight againstthe front railto
bringthe c_p intoaiigr_'_ent.
•When the clamps arecorrectlypositioned, retightenthe
scows and the setscrews.
•Pushboth front and rearmiter lockingclamps down to
securethe s|idingmiter table.
SCREW
Fig.66
TO ADJUST THE FRONT AND REAR RAIL
CLAMPS
See Rgure 67.
Therail crampsate locatedbelow theraUsand ensuretight
attachmentof therail. Followrngextended use,the rail
holdernut insidetherails may need adjusting.
• Unplugthe saw.
• Remove themiter table and accessory tabla.
•Removethe _ont emdrear rails by looseningthe rail
crampsand dlding the rai_soff.
•Rotate eachrail clamp to the {sft unti{ithits or comes in
correctwith the bo'_om otthe saw table.
•Tightenraitholder nut until it is snug.
•Loosenrail holder nutone-fourth (1/4) turn.
•Replacethe rails and check the rail clamps.
44
RAILHOLOER
NUT
RAIL
CLAMP
WASHER
HE)(MOUNTING
BOLT
Fig. 67
TO ADJUST THE ACCESSORY TABLE
See Rgure 68.
Afterextended use, the acce..-_, tab/e may workloose
caus(_ th_accessorytable to be {oos_ o_the ra'_s.
Foi(owthe stepsbelow,when adjustmentsare required:
•Unplugthe saw.
•Removethe hexnut on the lever usings 3/8 in. nut
driver.
•Removet_e backup p{ateand springplate. Rotate the
springplate 180°and reinstallon the handleshaft.
• Reassemble allparts end tighten hexnut securely.
NOTE;The spring plate offers two endsfor use before
re_[uiringreplacement.
ACCESSORYTABLE
LEVER
HAl RING
_"IAFT SPRINGPLATE
BACKUP
PLATE HEXNUT F_.68