Daktronics All Sport 5000 Single Controller Systems Channel Setting, Broadcast Group Setting

Single Controller Systems Channel Setting

Typically all single controller systems will use the default setting BCAST = 1, CHAN = 1. All radio receivers must be set with a switch setting of 1 with the Broadcast 1 (BCAST 1) jumper set.

If you suspect interference from a nearby Daktronics system, press <CLEAR> at the “RADIO SETTINGS” prompt to change the channel number.

Typically all multiple controller systems will use channel 1 for the first controller. All other controllers will use sequential channel settings (2-8). The following table describes broadcast channel and channel settings.

	LCD Display			Action
	RADIO SETTINGS		The LCD shows the current radio settings along
	BCAST Y CHAN XX		with a prompt to accept or modify these values.
The LCD will toggle these			If the radio settings are correct press <ENTER>
screens.
			If these values are incorrect press <CLEAR>
	bcast group 1		If <CLEAR> is pressed to modify the radio settings
	radio chan 01		the LCD at the left is shown, allowing edit of the
			channel or broadcast group setting.
			Edit the broadcast setting. Use the number keys to
			enter the desired broadcast group and press
			<ENTER> to accept.
	Enter to accept		Broadcast Group Setting
	clear to modify	1		Use this setting for all single controller
The bottom line shows				systems the asterisk will move to the
default settings.				channel setting. Use the number keys to
				edit this value and press <ENTER> to
				accept. Edit the channel number to the
				desired value and press <ENTER> to
				accept.
			Channel Setting
			1-8 Channels that may be used with broadcast
				channel 1. The channel switch on the
				receiver must match this value and only the
				Broadcast 1 (BCAST1) jumper must be
				installed.

28 Basic Operations