Daktronics All Sport 5000 manual Enter to accept Clear to modify

Multiple Controller w/Single Broadcast Group Channel Setting

Typically all single controller systems will use Broadcast 1 and Channel 1 for the first controller and Channels 2-8 for all remaining controllers. All radio receivers must be set with a switch setting corresponding to the console controlling the scoreboard and a Broadcast 1 (BCAST 1) jumper set.

If you suspect interference from a nearby Daktronics system, press <CLEAR> at the “RADIO SETTINGS” prompt to change the channel number.

Typically all multiple controller systems will use channel 1 for the first controller. All other controllers will use sequential channel settings (2-8). The following table describes broadcast group and channel settings.

	LCD Display			Action
	RADIO SETTINGS		The LCD shows the current radio settings along
	BCAST Y CHAN XX		with a prompt to accept or modify these values.
			If the radio settings are correct press <ENTER>.
			If these values are incorrect press <CLEAR>
	Enter to accept
	Clear to modify		If <CLEAR> is pressed to modify the radio settings
The LCD will toggle			the LCD at the left is shown, allowing edit of the
these screens			channel or broadcast group setting.
			To edit the broadcast setting, use the number keys
	bcast group 1
			to enter the desired broadcast group and press
	radio chan 01		<ENTER> to accept.
The bottom line shows			Broadcast Group Setting
default settings.
		1-		Use this setting for all multiple controller
				with single broadcast group setups. The
				asterisk will move to the channel setting.
				Use the number keys to edit this value and
				press <ENTER> to accept. Edit the
				channel number to the desired value and
				press <ENTER> to accept.
			Channel Setting
			1-8 Channels that may be used with broadcast
				channel 1. The channel switch on the
				receiver must match this value and only the
				Broadcast 1 (BCAST1) jumper must be
				installed.

Basic Operations 29