REFERENCES

5.14.2Copy PowerScan™ M8300 Series

Procedure:

cUsing the slave reader and its BC-80X0 cradle, follow the initialization procedure in chapter 4 of this manual or from the Quick Reference Guide.

dWith the master PowerScan™ M8300 (correctly configured reader), read the Copy Configuration barcode below. Then place it onto an BC-80X0 cradle within 10 seconds. The reader will beep indicating the configuration has been copied.

The configuration will be simultaneously sent over the RS-232 interface of the BC-80X0. If this causes undesired effects disconnect the RS-232 cable between the PC and BC-80X0 during this process.

Copy Configuration

Ì$+ZZ0$-*Î

eWith the slave PowerScan™ M8300, read the Get Configuration barcode below. Then place it onto the same BC-80X0 cradle used in the step above. The slave reader's address will not be changed.

Get Configuration

Ì$+ZZ2$-4Î

The configuration will be copied from the master to the slave PowerScan™ M8300. The slave PowerScan™ M8300 signals the end of the procedure with a series of beeps. It is now ready to be used with its own BC-80X0 cradle.

fRepeat the procedure above to configure other slave readers. The BC-80X0 can continue to configure slave readers until it receives another command or data.

167