POWERSCAN® D8330/M8300

4.3POWERSCAN® D8330 SETUP

1.Read the restore default parameters code below.

Restore PowerScan® D8330 Default

Ì$+$*oÎ

After reading the above code, go to par. 4.8 Interface Selection.

4.4POWERSCAN® M8300/BC-80X0 POINT-TO-POINT SETUP

A rapid configuration procedure has been devised for point-to-point applications where a single reader is associated exclusively with its own BC-80x0 base station and where it is not necessary to set the Date and Time parameters.

A special pre-printed bind-address label provided in the BC-80x0 base station package can be used to bind the PowerScan® M8300 reader to the base station with the address coded on the label. The address is also written numerically on the label to be easily recognized. Valid addresses are in the range from 0000 to 1999. Make sure that all cradles used in the same area have different addresses.

To rapidly configure your point-to-point application:

1.Apply the bind-address label onto the BC-80x0 base station as indicated in the BC-80x0 Quick Reference Guide.

2.When the BC-80X0 cradle is connected and powered, read the Bind-Addresslabel to pair the PowerScan® M8300 to the BC-80X0 cradle.

The green LED on the PowerScan® M8300 will blink: the reader is ready to be positioned onto the cradle.

3.Firmly position the reader onto the cradle within 10 seconds, a beep will be

emitted, signaling that the BC-80X0 cradle has been paired to the PowerScan® M8300, and the green LED on the reader will go off.

Green LED

If it ever becomes necessary to change the reader, just read the bind-address label applied to the cradle and position the new reader onto the cradle.

Do not use multiple readers with this configuration method.

4.Configure the BC-80X0 cradle, refer to the “BC-80X0 Quick Reference Guide”.

END of procedure. YOUR READER IS NOW READY TO READ CODES.

26