INSTALLATION

If using the adhesive strips:

a.Carefully clean the adhesive strip seats of the base to remove any impurities that could reduce adhesion.

b.Remove the protective plastic from one side of the adhesive strips and stick them onto the base surface.

c.Remove the plastic from the other side of the strips and affix the base to the wall as indicated in the figure below.

If using the mounting screws:

3. Using the mounting holes on the base as a pattern, mark the wall where you desire to mount the BC- 80X0/C-8000.

4. Drill the appropriate size holes and insert the threaded dowels (not provided) into the holes.

5. Position the base on the wall as indicated in the figure below and affix it by means of the screws (not provided).

Inclined Base Wall-mounting

6. Attach the cradle on the base by sliding it along the mounting tabs until aligned.

7. If mounting the BC-80X0 cradle, insert the antenna in the appropriate hole on the body of the cradle and screw it clockwise until tight.

17