Datalogic Scanning D8330, M8300 A HOST CONFIGURATION STRINGS, $+ Command $- CR, Example:, This method requires the RS-232interface

HOST CONFIGURATION STRINGS

A HOST CONFIGURATION STRINGS

In this section we provide a description of how to modify the device configuration using serial strings sent from the Host.

This method requires the RS-232 interface.

The device configuration can be changed by receiving commands from the Host through the serial interface. When this method is used, the programming sequence format is the following:

$+ Command $- CR

Carriage return character (0D Hex.)

Exit and Save configuration

Character sequence in following tables Enter configuration environment

Example:

Multiple command programming sequence:

$+ BG1 BH0 AC410132 $- CR

Carriage return character (0D Hex.)

Exit and save new configuration

Matrix 2/5 3 bars: no check digit,

variable length code from 1 to 32 characters Beeper tone 1

Beeper low intensity Enter configuration environment

Each configuration parameter setting removes the condition previously active for that parameter.

	The device buffer can contain about 400 characters. If your
	programming string goes over this value, you must split it into separate
	groups and send each group after a delay of at least 3 seconds to give
NOTE	the reader time to empty the buffer and interpret the commands.

183