Enter Configuration

 

Exit and Save Configuration

Ì$+;Î

DATA FORMAT

Ì$-?Î

 

 

 

 

CHARACTER REPLACEMENT

 

‹disable character replacement

ÌEO0mÎ

This parameter allows up to three characters to be replaced from the barcode read. These substitutions are stored in memory. To define each character replacement:

cRead one of the following character replacement codes:

first character replacement

ÌEO1pÎ

second character replacement

ÌEO2sÎ

third character replacement

ÌEO3vÎ

dFrom the Code Identifier Table in Appendix B, read the Code Identifier for the desired code family.

0 = character replacement will be effective for all code families.

eFrom the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE), which identifies the character to be replaced. For Wedge and USB-KBD interfaces, it is also possible to read the Special Key(s) on page 74.

fFrom the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE), which identifies the new character to replace. For Wedge and USB-KBD interfaces, it is also possible to read the Special Key(s) on page 74.

FF = the character to be replaced will be substituted with no character, that is, it will be removed from the code.

77