Datamax ST-3210, SV-3306, ST-3306, SV-3210 manual

To use roll ticket stock, the stock must be mounted on the optional Roll Hanger, as shown. (See Section 6 for stock requirements.)

þ Note: To use an internal fanfold ticket source on a printer equipped with the Roll Hanger option, first remove the Roll Hanger by unscrewing it from the printer. Store the hanger in a safe place for future use.

•Loosen the Thumbscrew and adjust the Media Guides to fit the width of the ticket stock: the guides should be positioned close enough to stop side-to-side ticket movement, but not so tight to cause friction or bowing of the ticket stock (see below). Tighten the Thumbscrew to secure the guides in place.

‘Slide the ticket stock through the Media Guides. The motor will start; continue sliding the tickets. The printer will grab the leading edge of the stock and complete the positioning process. Close the Access Cover.

þNotes: If automatic loading doesn’t occur:

1)Ensure that the Printhead Latch is locked.

2)Press the PAUSE button (the On-Line Indicator should be ‘Off’ now).

3)Repeatedly press the F2 button while gently pushing the stock forward until the printer grabs the ticket.

4)Press the PAUSE button (to return to the on-line mode).

If the ticket was not fed to a proper position, the TOF Sensor may need adjustment; see Section 4 for details.

ST/SV-3210 and ST/SV-3306 11