Datamax SV-3306, ST-3210, ST-3306, SV-3210 manual Start of Print & Cut/Tear Adjustment

4.2Start of Print & Cut/Tear Adjustment

If none of the preset Stock ID parameters meet the needs of your application, then the Start of Print (SOP) and Cut/Tear (C/T) Adjustments can be used to visually set the required positions. To begin:

ΠIf on-line, press the PAUSE button to place the printer off-line.

• Press and hold (approximately 6 seconds) the F3 button until the On- Line Indicator is lit then release. The SOP setup is first, to adjust:

ØPress the F1 button to increase the current distance (pressing and holding will rapidly move the ticket).

ØPress the F2 button to decrease the current distance (pressing and holding will rapidly move the ticket).

ØPress the F3 button to print a ticket showing the new setting.

ŽAfter completing the SOP adjustment, press and hold (approximately 6 seconds) the F3 button until the On-Line Indicator is lit then release.

• Next, adjust the Cut/Tear position using the F1, F2 and F3 buttons as described above.

• After completing the Cut/Tear adjustment, return the printer to

the off-line mode by pressing and

holding the F3 button until the On-Line Indicator is lit then release.

‘Press the PAUSE button to return to the on-line mode.

þNotes: This procedure must be performed in its entirety, even when no change is desired for one of the settings.

After completing the adjustments, always confirm the new settings by printing several test tickets.

If cutting, the cut position on the ticket should occur just behind the perforation, never in front of the perforation.

26 ST/SV-3210 and ST/SV-3306