4.1Stock ID Selections
The printer maintains a selection of 10 user modifiable stock setups. Each setup defaults to a specific print width, start print position and cut/tear position, where:
Ø The Print Width is the print distance across the ticket.
Ø The Start of Print Position is the distance, measured in inches, from the TOF Sensor to printhead burnline.
ØThe Cut/Tear Position is the distance, measured in inches, from the TOF
Sensor to the cut (if equipped) or tear position of the printed ticket.
The Stock ID can be set using the Operational Database Modification procedure (see Section 4.3.1). As defined on the following page, Stock ID numbers 0 through 8 are not changeable through host commands; however, Stock ID 9 will allow host commands to override the default settings.
If none of the listed Stock ID selections fit your media, select the Stock ID that is closest to the physical dimensions of your stock and then modify the Start of Print and Cut/Tear positions (see Section 4.2). All changes can be saved to the Stock ID, allowing commonly used formats to be recalled. To revert to the default values, reset the printer (see Section 3.6).
24 |
|
