Datamax SV-3306, ST-3210, ST-3306, SV-3210 manual Ticket Stock Requirements

Print Engine (continued)

Maximum Fields and	600 fields with 16,000 characters per ticket
Characters Per Ticket:
Tear Bar:	Tear up/down
DRAM Memory:	4 MB
Internal Module Size:	512 KB (default)
Scalable Module Size:	256 KB (default)
EPROM Memory:	1 MB

Ticket Stock Requirements

Type:	Fan-fold and roll (if option equipped)
	reflective[1] direct thermal stock.
Maximum Ticket Width:	3.25 inches (82.55 mm)
Minimum Ticket Width:	1.9 inches (48.2 mm)
Ticket Thickness Range:	.005 inch – .010 inch (.13 mm – .25 mm)
(if Cutter option equipped):	.025 inch – .008 inch (.06 mm – .2 mm)
Fanfold Ticket Length	11.375 inches (289 mm) maximum for interior
(ST models only):	placement of the stock.
Fanfold Ticket Height	4.5 inches (114.3 mm) maximum for interior
(ST models only):	placement of the stock.
Roll Capacity	7.0-inch (177.8 mm) maximum outer diameter
(if Roll Hanger option	rolls of ticket stock wound with the TOF Marks
equipped):	facing inward, on 2.0-inch (50.8 mm) diameter
	cores.

[1]The reflective TOF Mark must be black, carbon based, and placed on the backside of the stock with a minimum size of .125 inch (3.175 mm) long (direction of travel) by

.5 inch (12.7 mm) wide, with the center falling between .235 inch (6 mm) and 3.03 inches (77 mm) from the edge while allowing adequate Quiet Zone space (see the diagram in Section 6.1). The reflectance of the mark shall be less than 10% at wavelengths of 950 and 640 nm.

46 ST/SV-3210 and ST/SV-3306