Datamax ST-3306, SV-3306, ST-3210, SV-3210 Resetting the Printer, Warm Reset, Factory Default Reset

3.6Resetting the Printer

There are two different reset levels possible for the printer:

3.6.1Warm Reset

To reset the printer and return to the on-line mode: Press the PAUSE button to go off-line and then press the F1 + F3 buttons simultaneously.

3.6.2Factory Default Reset

To return the printer to default database settings (see the table below), perform the following procedure.

ŒTurn the printer ‘Off’.

•Press and hold the PAUSE/F1, FEED/F2 and TEST/F3 buttons while turning ‘On’ the printer.

ŽAfter the Fault Indicator flashes (approximately 20 seconds), release all three buttons.

For verification, a Configuration Ticket can be printed. The printout will reflect default settings until new configuration data is sent to the printer.

Default Database Settings

Function	ST/SV 3210 Values	ST/SV 3306 Values
Memory Configuration: [1]	128	128
Internal Module
Scalable Fonts	64	64
Character Set:	Standard	Standard
(DPL parser mode only)
Cutter	Auto Detect	Auto Detect
Parser Mode:[2]	DTPL	DTPL
Print Speed: [3]	8	4
Slew Speed: [3]	8	4
Backup Speed: [3]	3	3
Stock ID	5	5
Print Width	1.89 inches (48 mm)	1.92 inches (49 mm)

[1]Memory allocations are represented in 4KB units each and modifiable only when in the DPL parser mode.

[2]The parser mode setting may arrive factory-configured to meet your application; otherwise see Section 4.3.1.

[3]All speed values given in Inches Per Second.

20 ST/SV-3210 and ST/SV-3306