Dell 531S owner manual Memory Installation Guidelines, 112, Pin Number Signal Name AWG Wire

Pin Number	Signal Name	22-AWG Wire
1	+5 VCD	Red
2	GND	Black
3	GND	Black
4	+12 VDC	Yellow

Memory

You can increase your computer memory by installing memory modules on the system board. Your computer supports DDR2 memory. For additional information on the type of memory supported by your computer, see "Memory" on page 167.

NOTICE: Do not install ECC or buffered memory modules. Only unbuffered, non-ECC memory is supported.

Memory Installation Guidelines

•DIMM connectors must be populated in a numerical order, beginning with connectors DIMM_1 and DIMM_2, then connectors DIMM_3 and DIMM_4. If a single DIMM is installed, you must install it in connector DIMM_1.

•For best performance, memory modules should be installed in pairs of matched memory size, speed, and technology. If the memory modules are not installed in matched pairs, the computer will operate, but with a slight reduction in performance. (See the label on the module to determine the module’s capacity.) For example, if you install a mixed pair of DDR2 667-MHz and DDR2 800-MHz memory, the modules function at the slowest speed installed.

112

Removing and Installing Parts