Dell E11S Removing the Expansion-Card Stabilizer, Installing the Expansion-Card Stabilizer

10Exit the System Setup program and reboot the system.

11Partition and logically format the drive.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

Expansion-Card Stabilizer

Removing the Expansion-Card Stabilizer

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system and attached peripherals. Disconnect the system from the electrical outlet and peripherals.

2Open the system. See "Opening the System" on page 45.

3Press the release tab and lift the expansion card stabilizer out of slots in the chassis. See Figure 3-15.

Installing the Expansion-Card Stabilizer

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Slide the edge of the expansion-card stabilizer into the slots in the cooling shroud and chassis until the release tab locks into place. See Figure 3-15.

2Close the system. See "Closing the System" on page 46.

Installing System Components

65