Dell R220 owner manual SEC0033 Message

Error Code	Message Information
SEC0033	Message	The chassis is open while the power is off.
	Details	The chassis was opened while the power was off. System
		security may have been compromised.
	Action	Close the chassis and verify hardware inventory. Check
		system logs.
SEL0006	Message	All event logging is disabled.
	Details	This message is displayed when all event logging has been
		disabled by the user.
	Action	If unintended, re-enable logging.
SEL0008	Message	Log is full.
	Details	When the event log is full, additional events are not written
		to the log. Older events may be overwritten and lost. This
		message may also appear if the user disabled event logging.
	Action	Backup and clear log.
SEL0012	Message	Could not create or initialize the system event log.
	Details	If the system event log fails to initialize, platform status and
		failure events are not captured. Some management software
		do not report platform exceptions.
	Action	Reboot the management controller or iDRAC. Cycle system
		input power. If problem persists call support.
SEL1204	Message	An unknown system hardware failure detected.
	Details	If the system event log failed to initialize, platform status and
		failure events are not captured. Some management software
		do not report platform exceptions.
	Action	Re-configure system to the minimum supported
		configuration. If issues persists, contact support.
TMP0118	Message	The system inlet temperature is less than the lower warning
		threshold.
	Details	Ambient air temperature is too cool.
	Action	Check the system operating environment.

90