5Release the WWAN card by removing the screw.

6Lift the WWAN card out of its system board connector.

Replacing a WWAN Card

NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and realign the card.

NOTICE: To avoid damage to the WWAN card, never place cables under the card.

1Insert the WWAN card connector at a 45-degree angle into the system board connector labeled "WWAN".

2Press the other end of the WWAN card down into the slot on the system board until the card clicks into place.

3Replace the M2 x 3-mm securing screw.

4Connect the black antenna cable with a gray stripe to the connector labeled "aux" (black triangle) and connect the white antenna cable with a gray stripe to the connector labeled "main" (white triangle).

5Secure unused antenna cables in the protective mylar sleeve.

6Replace the cover and tighten the captive screw.

Adding and Replacing Parts

149

Page 149
Image 149
Dell RW491 owner manual Replacing a Wwan Card, 149