Manually Reinstalling Drivers

NOTE: If your computer has a Consumer IR port and you are reinstalling a Consumer IR driver, you must first enable the Consumer IR port in the system setup program (see "Dell Technical Support Policy (U.S. Only)" on page 173) before continuing with the driver installation (see "Reinstalling Drivers and Utilities" on page 117). For information about components installed on your computer, see "Determining Your Computer’s Configuration" on page 19.

1After extracting the driver files to your hard drive, as described in the previous section, click Start , and then right-click Computer.

2Click Properties, and then click Device Manager.

3Double-click the type of device for which you are installing the driver (for example, Modems or Infrared devices).

4Double-click the name of the device for which you are installing the driver.

5Click Driver tab, and then click Update Driver.

6Click Install from a list or specific location (Advanced), and then click Next.

7Click Browse and browse to the location to which you previously copied the driver files.

8When the name of the appropriate driver appears, click Next.

9Click Finish, and then restart your computer.

Troubleshooting Software and Hardware

Problems in the Windows Vista® Operating

System

If a device is either not detected during the operating system setup or is detected but incorrectly configured, use Windows Vista Help and Support to resolve the incompatibility.

NOTE: Windows Vista® is a new operating system, so drivers or applications that support certain devices may not yet be available. Check with your hardware manufacturer for information on Windows Vista support for your device.

Troubleshooting

119

Page 119
Image 119
Dell RW491 owner manual Manually Reinstalling Drivers, 119