Table 5-2. Pre-Installation Procedures For The Controller Drivers (continued)

Procedure

Steps

 

 

6 Change the Boot

To change the order of the devices (CD-ROM, optical

Priority List

DVD, and so on), perform the following:

for Devices (if

NOTE: Unless mentioned otherwise, the term PERC Virtual

applicable)

Disk Management utility refers to both the PERC S100 Virtual

 

 

Disk Management utility and the PERC S300 Virtual Disk

 

Management utility.

 

NOTE: If the PERC Virtual Disk Management utility is open,

 

select Continue to Boot, then press <Enter>. Press

 

<Ctrl><Alt><Delete> to reboot the system.

 

a Boot the system. When the POST screen appears,

 

press <F2>.

 

b At the Dell PowerEdge System screen, use the arrow

 

keys to scroll to Boot Sequence. Press <Enter>.

 

c Make sure that Hard drive C: is the first device

 

listed.

 

d To change the sequence of other devices:

 

•Use the <+> key to move devices up, or the <-> key

 

to move devices down.

•Use the space bar to enable or disable a device.

ePress <Esc> to exit.

fPress <Esc> again. Select Save Changes and Exit and press <Enter>.

NOTE: Continue with one of the following procedures:

"Installing the Controller Drivers During the Operating System Installation: For Systems with a PERC S100 Adapter" on page 42

"Installing the Controller Drivers During the Operating System Installation: For Systems with a PERC S300 Adapter" on page 44

Installing the Drivers

41

Page 41
Image 41
Dell S100, S300 manual DVD, and so on, perform the following