![](/images/new-backgrounds/1192733/19273379x1.webp)
Table 5-2. Pre-Installation Procedures For The Controller Drivers (continued)
Procedure | Steps |
|
|
4 Create a bootable | See "Creating Virtual Disks" on page 51. |
virtual disk |
|
5 Check controller options and the boot list priority
aAt the PERC S100 Virtual Disk Management utility or PERC S300 Virtual Disk Management utility, use the arrow keys to select Controller Options. Press <Enter>. Make sure that Toggle INT13 Boot Support is ON. Press <Esc> to exit.
bAt the Virtual Disks field, make sure the bootable virtual disk created in Procedure 4, is the first virtual disk listed.
If the bootable virtual disk is not the first virtual disk listed, see "Swapping Two Virtual Disks" on page 55.
NOTE: If
c Select Continue to Boot and press <Enter>.
NOTE: If the next Procedure (6) is not applicable, continue with one of the following procedures:
•"Installing the Controller Drivers During the Operating System Installation: For Systems with a PERC S100 Adapter" on page 42
•"Installing the Controller Drivers During the Operating System Installation: For Systems with a PERC S300 Adapter" on page 44
40
Installing the Drivers