Chapter 4
Installation Instructions
Two Dishes, One DishPro Twin LNBF, One DishPro Single
LNBF, One DishPro Compliant Splitter, Two DishPro 21
Switches, Two Receivers
This diagram leaves out grounding to be clear. Make sure you ground the system per the National Electrical Code (NEC) and all local electrical codes.
*
* When using a DishPro compliant splitter to split the signal from a DishPro single LNBF, the receiver whose DP21 switch is connected to the passing side of the splitter must be plugged into a live power outlet at all times. If not, the DishPro single LNBF will not have any power and will not be able to provide satellite signal to the other receiver.
When you set up your system following this diagram and run Check Switch the Installation Summary screen should look similar to the one shown below.
Page 64
