Appendix A
Warning: Tighten all the coaxial cable connections only by hand.
Using a wrench may
Such damage is not covered by the Limited Warranty.
2.Connect a coaxial cable from the TV SET OUT connection on your receiver to your television's RF tuner input. Peel off the white sticker and affix it to the cable close to where it connect to the TV SET OUT connection on the back of the receiver.
3.Plug in the receiver's power cord. Make sure both the receiver and TV are turned on.
4.You should see the Point Dish/Signal Strength menu in the new receiver. If you do not, open the Main Menu, by pressing MENU fol- lowed by
5.Select Check Switch. Select Test to run Check Switch.
6.When Check Switch is complete, you will see an Installation Sum- mary screen. If the screen shows the correct switch and the message "Satellite reception verified" for all satellites in your system, go to step 7. If the Installation Summary screen does not detect all of the satellites your system should be receiving, check and retighten (by hand) the cable connections between your receiver, LNBFs and switches in your system. Then press Test to rerun Check Switch again.
7.Select OK to return to the Point Dish/Signal Strength screen. Then select Cancel to exit the Point Dish/Signal Strength screen.
8.An Attention screen will open asking if the mounting and positioning of your dish is complete with a "Locked" indication in the Point Dish/Signal Strength screen. Since your system is already installed and your dish is pointed for the strongest possible signal strength, you can select Yes.
9.The receiver will begin taking a software upgrade. You will see the message shown below.
A progress bar at the bottom of the screen will show how the software upgrade is progressing. Once the software upgrade is complete, you will see a second message that the receiver's memory is now being programmed.
This message may disappear, your screen may go blank for a few minutes, and the green light may continue to blink. This is normal and does not indicate a problem with the receiver.
10.When the software upgrade is complete, press VIEW TV and you should now be able to watch TV programming. To activate your pro- gramming on this newly installed receiver, call
Page 84
