Chapter 9
Improving Receiver Control
IMPROVING RECEIVER CONTROL
These instructions help you improve your remote control settings to best operate your satellite receiver.
Changing the Address
Because UHF signals travel long distances and go through walls, a neighbor’s remote may control your receiver by mistake. To keep this from happening, you can change the remote address.
1Press SYSTEM INFO on the receiver's front panel. The System Information screen displays and shows the Remote Address.
Write down the address shown:
2Press and hold SAT on your remote control for about three seconds, until all of the mode buttons light up, and then let go of SAT.
3Use the NUMBER PAD to enter any number between 1 and 16, but not the one you wrote in step 1.
4Press POUND (#). If you entered the address correctly, SAT will flash three times. Write down the number you entered:
5Press RECORD. Make sure the Remote Address you see on the System Information screen is the same as the one you entered in step 3. If it isn't, the remote cannot control the receiver.
6Press SELECT to close the System Information screen.
46
