Remote Control Setup
Recover Button
Controlling the TV’s Volume
1Press TV for four seconds, and then let go of it. TV will blink.
2Press POUND (#).
3Press the plus (+) side of VOLUME.
4Press ZERO (0).
5Press POUND (#). TV flashes three times.
Now make sure the remote controls the TV’s volume:
6Press SAT.
7Press the plus (+) and minus
RECOVER BUTTON
Use RECOVER if you accidentally change the channel or video input on your TV and cannot get the picture back from your satellite receiver. When you press RECOVER as described below, the remote control sends commands to your TV to change channels or video inputs to try to get you back to watching satellite programming. This procedure works only if you have accidentally changed the TV channel or video input. It does not recover lost satellite signal (See Troubleshooting on page 82 for information on solving problems).
Note: The remote must be programmed to control the TV (and VCR, if applicable) for RECOVER to work as described.
Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video inputs with each press of RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV video.
The following setup is required to use RECOVER:
•The remote control must be set up to control the TV and, if installed, the VCR.
•If a VCR is installed, make sure it is connected as shown on page 74.
55
