Draytek 5500 Series manual For VigorPro, Led

1.2.1 For VigorPro 5500

LED		Status	Explanation
ACT (Activity)		Blinking	The router is powered on and running normally.
		Off	The router is powered off.
Virus		On	The anti-virus function is enabled.
		(Yellow)
IDP (Intrusion Detection and		On	The anti-intrusion function is enabled.
Prevention)		(Yellow)
DMZ		On	DMZ Host is specified in certain site.
Monitor		On	LAN traffic monitor is active.
VPN		On	The VPN tunnel is launched.
		Off	The VPN tunnel is closed.
QoS		On	The QoS function is active.
LED on Connector
	10	On	The port is connected with 10Mbps.
WAN	(left LED)	Off	The port is disconnected.
		Blinking	The data is transmitting.
	100	On	The port is connected with 100Mbps.
	(right LED)	Off	The port is disconnected.
		Blinking	The data is transmitting.
LAN/Monitor	100	On	The port is connected with 100Mbps.
LAN	(left LED)	Off	The port is disconnected.
		Blinking	The data is transmitting.
	1000	On	The port is connected with 1000Mbps.
	(right LED)	Off	The port is disconnected.
		Blinking	The data is transmitting.

Interface	Description
RST	Restore the default settings.
(Factory Reset)	Usage: Turn on the router (ACT LED is blinking). Press the hole and keep
	for more than 5 seconds. When you see the ACT LED begins to blink rapidly
	than usual, release the button. Then the router will restart with the factory
	default configuration.
WAN(1/2)	Connecter for remote networked devices.
LAN/Monitor	Connecter for local networked devices.
LAN (1-4)	Connecter for local networked devices.
	Connecter for a power cord with 100-240VAC (inlet).
	Power Switch. “1” is ON; “0” is OFF.

2 VigorPro5500 Series User’s Guide