Details Page for PPPoE

To use PPPoE as the accessing protocol of the internet, please choose Internet Access from WAN menu. Then, select PPPoE mode for WAN2. The following web page will be shown.

PPPoE Client Mode

Click Enable for activating this function. If you click Disable, this

 

function will be closed and all the settings that you adjusted in this

 

page will be invalid.

ISP Access Setup

Enter your allocated username, password and authentication

 

parameters according to the information provided by your ISP. If

 

you want to connect to Internet all the time, you can check Always

 

On.

 

Username – Type in the username provided by ISP in this field.

 

Password – Type in the password provided by ISP in this field.

 

Index (1-15) in Schedule Setup - You can type in four sets of time

 

schedule for your request. All the schedules can be set previously

 

in Application – Schedule web page and you can use the number

 

that you have set in that web page.

PPP/MP Setup

PPP Authentication – Select PAP only or PAP or CHAP for

 

PPP.

 

Idle Timeout – Set the timeout for breaking down the Internet

 

after passing through the time without any action. This setting is

 

active only when the Active on demand option for Active Mode is

 

selected in WAN>> General Setup page.

IP Address

Usually ISP dynamically assigns IP address to you each time

Assignment Method

you connect to it and request. In some case, your ISP provides

(IPCP)

service to always assign you the same IP address whenever

 

you request. In this case, you can fill in this IP address in the

 

Fixed IP field. Please contact your ISP before you want to use

 

this function.

 

WAN IP Alias - If you have multiple public IP addresses and

 

would like to utilize them on the WAN interface, please use WAN

 

IP Alias. You can set up to 8 public IP addresses other than the

 

current one you are using.

VigorPro5500 Series User’s Guide

25

Page 33
Image 33
Draytek 5500 Series manual Details Page for PPPoE