Draytek 5500 Series manual Management

3.16.6 Management

This page allows you to manage the settings for access control, access list, port setup, and SNMP setup. For example, as to management access control, the port number is used to send/receive SIP message for building a session. The default value is 5060 and this must match with the peer Registrar when making VoIP calls.

Enable remote firmware	Chick the checkbox to allow remote firmware upgrade through
upgrade	FTP (File Transfer Protocol).
Allow management from	Enable the checkbox to allow system administrators to login
the Internet	from the Internet. By default, it is not allowed.
Disable PING from the	Check the checkbox to reject all PING packets from the
Internet	Internet. For security issue, this function is enabled by default.
Access List	You could specify that the system administrator can only
	login from a specific host or network defined in the list. A
	maximum of three IPs/subnet masks is allowed.
	List IP - Indicate an IP address allowed to login to the router.
	Subnet Mask - Represent a subnet mask allowed to login to
	the router.
Default Ports	Check to use standard port numbers for the Telnet and HTTP
	servers.
User Defined Ports	Check to specify user-defined port numbers for the Telnet and
	HTTP servers.
Enable SNMP Agent	Check it to enable this function.
Get Community	Set the name for getting community by typing a proper
	character. The default setting is public.
Set Community	Set community by typing a proper name. The default setting is
	private.
VigorPro5500 Series User’s Guide	157