11Using other functions
1During recording, press the REC SELECT CONTROL button on the front panel until RECOUT shows in the display.1
2While RECOUT shows in the display, use the
INPUT SELECTOR dial to select the source you want to record.
The default, RECOUT SOURCE, records the source you’re currently listening to (as in Press RETURN to confirm and exit the menu. above).
•Note that the setting you make here is stored in memory, even if you switch off the receiver, so if you want to record a different input source later, you must do so with REC SELECT, or by selecting
RECOUT SOURCE.
3After RECOUT disappears from the display, select the input source you want to listen to.
This will be heard from the main system without affecting your recording.2
Reducing the level of an analog signal
The input attenuator lowers the input level of an analog signal when it’s too strong. You can use this if you find the that the OVER indicator is lights often, or you can
hear distortion in the sound.3
SLEEP | DIMMER | ANALOG |
|
| ATT |
SR+ | GENRE |
|
D.ACCESSCLASS
SC
•Press ANALOG ATT to switch the input attenuator on or off.
•You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again.4
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.
SLEEP | DIMMER | ANALOG |
|
| ATT |
SR+ | GENRE |
|
D.ACCESSCLASS
•Press DIMMER repeatedly to change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating.
1With the receiver in standby, press STANDBY/
ON while holding down the SETUP button.
2Select SPEAKER using /, then select 8 Ω or 6 Ω using /.
•SPEAKER 6 Ω – Use this setting if your speakers are rated at 6 Ω.
•SPEAKER 8 Ω – Use this setting if your speakers are rated at 8 Ω or more.
Using the sleep timer
The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without worrying about the receiver being left on all night. Use the remote control to set the sleep timer.
SLEEP | DIMMER | ANALOG |
|
| ATT |
SR+ | GENRE |
|
D ACCESS |
| CLASS |
•Press SLEEP repeatedly to set the sleep time.
30 min | 60 min |
Off | 90 min |
Note
1If RECOUT does not appear in the display, you may have to switch ZONE 2 off by pressing MULTI ZONE & SOURCE ON/OFF and selecting either ZONE 3 or off (the
2If RECOUT SOURCE is selected, changing the input source likewise changes the input source used for your recording.
3The attenuator isn’t available with digital sources, or when using the Stream Direct modes.
4You can also switch off the sleep timer simply by switching off the receiver.
74
En
