Dukane 403570-01 user manual 35Password-Protected Screens and Menus

Section 5 - Touch Screen Menus

The Home Offset (Deg..) field is used to specify an angular offset of the homing spin orientation. The tooling hub home orientation is set at the factory such that the slot in the hub shown in Figure 3-2a is closest to the front of the machine. This position is the 0 degree reference for the spin motor and all spin orientations are defined relative to it. Unless a specific situation requires a non- zero offset, it is most convenient to retain the factory default value.

The Set Password button is used to set the password, which must subsequently be entered to change programmed machine settings. The default password is 0 (zero) so that password–protected screens are easily accessed by just pressing the Enter key on the Enter Password Code screen. The password is a numerical value with a maximum 10–digit value of 4 294 967

295.The password–protected screens and menus are shown in Figure 5–35.

The buttons English, French, Czech, and German set the active language on the welder. When one of these buttons is pressed, the menu language changes to the selected language and remains in effect while the welder is powered up. To preserve the language selection between power cycles, press the Save Language Select button.

The Software Info button displys a screen with software revisions of the welder components as shown in Figure 5-36.

RUN
SETUP	PRE-
	WELD	WELD
		POST-
		WELD
TOOLS	SELECT
	SETUP
		UTILITIES
		SYSTEM
		SETUP
		Set Password

Figure 5–35Password-Protected Screens and Menus

Figure 5–36Welder Software Information

Dukane Manual Part No. 403-570-01 Page  45