Eagle Electronics 1000C manual Preparations, Transducer Installation

Section 2:

Installation & Accessories

Preparations

You can install the sonar and GPS systems in some other order if you prefer, but we recommend this installation sequence:

CAUTION:

You should read over this entire installation section before drilling any holes in your vehicle or vessel!

1.Determine the approximate location for the sonar/GPS unit, so you can plan how and where to route the cables for the antenna, transducer and power. This will help you make sure you have enough cable length for the desired configuration.

2.Determine the approximate location for the transducer and its cable route.

3.Determine the approximate location for the GPS antenna module and its cable route.

4.Determine the location of your battery or other power connection, along with the power cable route.

5.Install the transducer and route the transducer cable to the sonar/GPS unit.

6.Install the GPS antenna and route the antenna cable to the sonar/GPS unit.

7.Install the power cable and route it to the sonar/GPS unit.

8.Connect the cables to the unit and mount the unit on the bracket.

Transducer Installation

These instructions will help you install your Skimmer transducer on a transom, on a trolling motor or inside a hull. These instructions cover both single- and dual-frequency Skimmer transducers. Please read all instructions before proceeding with any installation.

The smaller single-frequency Skimmers typically use a one-piece, stainless steel mounting bracket. The larger dual-frequency Skimmers typically use a two-piece, plastic mounting bracket. The trolling motor mount uses a one-piece plastic bracket with an adjustable strap.

These are all "kick-up" mounting brackets. They help prevent damage if the transducer strikes an object while the boat is moving. If the transducer does "kick-up," the bracket can easily be pushed back into place without tools.

13