30
Rear adjustment feetImage Projection
Front adjustment
foot
HEIGHT ADJUST button
Side View
Lens
center
Top View

Using the Adjustment

Feet

The height of the projector can be adjusted
using the adjustment feet at the front and rear
of the projector when the screen is located
higher than the projector, the screen is inclined
or when the installation site is slightly inclined.
Install the projector so that it is as perpen-
dicular to the screen as possible.
1

Press the HEIGHT ADJUST button.

•The front adjustment foot comes out.
2Lift the projector to adjust its

height while pressing the

HEIGHT ADJUST button.

•The projector is adjustable up to approxi-
mately 12 degrees (6 steps).
•When lowering the projector, it may be
difficult to move the front adjustment foot
because the installation surface is diffi-
cult to slide. In this case, pull the pro-
jector back slightly and adjust its height.
3Remove your hand from the

HEIGHT ADJUST button of the

projector after its height has

been finely adjusted.

4Finely adjust the height and in-

clination by turning the rear ad-

justment feet.

•When adjusting the height of the pro-
jector, trapezoidal distortion occurs.
When “Auto Keystone” of the “Options2”
menu is set to “ ” (ON) (see page 57),
keystone correction functions automati-
cally to correct trapezoidal distortion.
When you want to adjust the automati-
cally corrected image, use the manual
keystone correction. (See page 31.)
Info
•Do not press the HEIGHT ADJUST button
when the front adjustment foot comes out
without firmly holding the projector.
•Do not hold the lens when lifting or lower-
ing the projector.
•When lowering the projector, be careful not
to get your fingers caught in the area be-
tween the adjustment foot and the projector.